Alright today Im going to show you howto oust the battery in the iPhone 6S. There are two ways to replace the battery thereis an easy way and theres a hard way. I will be proving you both access. The actualbattery permutation let us begin at the 1:15 brand. I will link tools and replacementbatteries down in the video description. So check those out if you need them. To get atthe battery you do have to open up the phone. With your pentalobe bolt operator you can removethe bottom 2 nails from the phone. Then you can lift up on the screen with a suction cupand move a tool between the metal make of the screen and the metal chassis of the phone.Pry it highly gently. There is adhesive surrounding the screen and the chassis. So Im going togo ahead and slip my plastic pry implement between the two and separate them.That clears it easierto lift off the screen from the chassis. Pretty straight forward. There are 4 clamps holdingdown this metal plate. I eliminating those 4 pins, lift off the metal plateful, and then disconnecteach of these little ribbon cables. You defiantly dont want to let the screen deform past 90 severities or it will impair the cables. Once the screen is removed you can see the littlebattery down now, and the little acquaintance for it.So just unscrew those two fucks, and remove the metal plate. So here is the wrong way to remove the battery. There arethese two little gather tabs down here at the bottom. You can see that I am unsticking itfrom the battery right now. They are kind of hard to grab because they shrink up assoon as you being withdrawn. Now is where I went wrong. I made the draw tab, formerly I got aholdof it, and attracted it through the side of the phone. Which determine the pull invoice shatter, andmakes it a harder repair.If you actually just take to pull tab and pull straight outthe bottom, and not around the battery like I am doing right now. Just pull straight outthe bottom, and you can see it pull out perfectly away from the battery. So easy. Now thatsone whole half of the battery that I dont have to unstick from the back. But since Imessed up on the first time around with the first draw invoice I “re going to have to” do the pry of shameto pluck the battery out from the back of the residence. The sticky tap is pretty strong stuff.The best mode to do it is just pull the little tab out from the bottom of the artillery andyank it right out.To leant the battery back in place you can buy new drag invoices or youcan only use do double-sided tape. Then fasten it down underneath the artillery so thatit doesnt fidget around inside of the housing. Take the artillery and push it back into place.Take the two pins and shaft them into the metal plate over the connection. Then youcan take the screen and plug in the connectors. You have the one for the breast facing camera, “youve had” the LCD, and “youve had” the digitizer. Once they are plugged into place they arelike little Legos. You time kind of plug them in. Before putting the metal layer down. Iam going to test to see if the screen is working. If you have strands or a grey screen thereis a good chance that one of your attachments isnt perfectly right so unplug connectit and re-plug in the ribbing cable. Then to line up the screen I generally take it andpush it into the top of the home first.Then I can slip my hands down the side ofthe screen to fasten it into situate. Get the two nails in at the bottom, and you are goodto go. If you have any questions make sure to leave them down in the comments. Dontforget to like if this video help me out here and dont forget to subscribe. Thanks a tonfor watching. Hope to see you around ..
